MicroStrategy ONE

Command Line

In command line mode, you type the appropriate information at the prompt and press Enter. Instructions are included on each page of the MicroStrategy Installation Wizard.

In some cases, you are asked to make a selection by pressing 1 or 2, and Enter. You then press 0 and Enter to continue.

Defaults appear next to each prompt and are enclosed in square brackets, for example, [1]. Click Enter to use the default, or type a different response to the prompt to override the default.

In addition, on the command line wizard pages, the following options are available:

  • Press 1 and then click Enter to proceed to the next page.
  • Press 2 and then click Enter to return to the previous page.
  • Press 3 and then click Enter to cancel the installation and close the MicroStrategy Installation Wizard.
  • On the last page, which is MicroStrategy Installation Wizard Complete, press 3 and then click Enter to complete the setup and close the wizard.

For information on command line installation, refer to Installing MicroStrategy on Linux.